МАНУАЛЫ

CANON BJС-5000

КОДЫ ОШИБОК
Error Power/Error LED Beeps Solution
Paper Feed / Delivery Steady 2 Remove any paper jammed
BJ Cartridge (Holder 1) not detected Steady 3 Re-install cartridge or replace it
BJ Cartridge (Holder 2) not detected Steady 4 Re-install cartridge or replace it
BJ Cartridge High heat error Blinks 5 Let cartridges cool, and retry, if not replace the faulty BJ cartridge
Waste Full Warning Blinks 6 Waste is almost full, needs service very soon
       
Service Errors Blinks 7 Requires service, However the following Errors may be corrected
Overheated Printhead / Failed Printhead Blinks Orange x7 7 May Need Printhead Replacing, see notes below
Overheated Printhead / Failed Printhead Blinks Orange x8 7 May Need Printhead Replacing, see notes below
BJ Cartridge Not Found Blinks Orange x9 7 A Cartridge is detected however there is a problem with the communication. May need a printhead replaced, see notes below

В случае, если по каким-то причинам (сгорела электрическая часть картриджа или плохой контакт) не определяется картридж, нужно убедиться ы исправном ли состоянии картридж (головка картриджа). Для этого:

  • Power on printer
  • Open Printer Cover
  • The Cartridges should center
  • Unplug Printer
  • Remove the printhead from Holder 2.
  • Close Printer cover
  • Replug printer in
  • Swap Printheads into Holder 1 until you have determine with Printhead is causing the error.
  • Replace the failed printhead (BJ Cartridge).
Canon BJC-5100-Self Test

Switch Printer off
Hold Power for 1 beep.
The Reset Procedure foe Canon BJC-5000 and BJC-5100
Switch off the printers
Press and hold RESUME button then press POWER button, The indicator will start blinking.
While the indicator is blinking , Press RESUME twice then Wait until the printer beeps to indicate service mode
When the indicator lights steady GREEN, press RESUME button four (4) times. The indicator should be GREEN.
Press Power to set data

Service Test Print

Turn off the printer Canon BJC-5000 and BJC-5100
Press and hold RESUME then press POWER, The indicator will start blinking.
While the indicator is blinking , Press RESUME twice then Wait until the printer beeps to indicate service mode
When the indicator lights steady GREEN, press RESUME button two (2) times. The indicator should be GREEN.
Press the Power button to Print

Nozzle Print

Power off printers Canon BJC-5000 and BJC-5100
Press and POWER, until heard beeps sound from the printer and release.
Demonstration Print
While the printer in ON , Press and hold RESUME button until the printer plays a melody of beeps.

2002-2009