МАНУАЛЫ

CANON BJС-7100

КОДЫ ОШИБОК
Power Error Beeps Error Condition Solution
Off Off   No Power  
On Off   Ready  
On On 1 Paper Pickup Error or out of paper Add Paper or clear paper jam and press the RESUME button
On Blinks 1 Low Ink Warning  
On On 2 Paper Jam Clear paper jam and press the RESUME button
On On 3 BJ Cartridge Check Insure a Printhead is installed or check installation of the printhead
On Blinks 3 Low Battery Warning Recharge the NiCAD battery
On On 4 Cartridge Mismatch Wrong type of cartidge is installed, ie IS scanner cartidge installed at time of printing
On Blinks 4 Waste Ink Warning Press RESUME to continue, though the printer will require a service.
Blinks Blinks Long + Short Low Battery Error Recharge the NiCAD battery if this fails replace the NiCAD
Blinks Blinks 1, 2 ROM / RAM or EEPROM fault Try unplugging the printer for 20 seconds, if this doesn't work then requires service
Blinks Blinks 3 Cartridge out of position Try reinstalling or replacing the cartridge, if this fails then it requires service
Blinks Blinks 4 Carriage home postion error Requires service
Blinks Blinks 5 Waste Ink Full Requires service
Blinks Blinks 6 Temperature Error Try replacing the Printhead, if this fails then the printer requires service
Blinks Blinks 7 Print position Requires service
Blinks Blinks 8 Temperature Error Try replacing the Printhead, if this fails then the printer requires service
Blinks Blinks 9 Diode error Try replacing the Printhead, if this fails then the printer requires service
Blinks Blinks 10 Cleaning Fault Requires service
Blinks Blinks 11 EEPROM Try unplugging the printer for 20 seconds, if this doesn't work then requires service

Сброс кода ошибки переполнения отстойника - "памперса"

1: Unplug Power Cord
2: Hold POWER and RESUME buttons
3: Plug in Power Cord
4: Release buttons after the printers starts up
5: Hold CARTRIDGE and RESUME
6: Press POWER
7: Release all buttons after the beeps
8: Press CARTRIDGE 16 times
9: Press RESUME
10: Unplug the Power cord


© E.Semenov, 2002-2008