МАНУАЛЫ

CANON BJС-610

КОДЫ ОШИБОК
Power Beeps Error Online BK C M Y Ink Env Error Condition Solution
On   OFF ON             Ready  
On 2 On               Paper jam or out of paper Add paper or remove the paper jam and press ONLINE to continue
On 2             Blink Blink WASTE INK warning You can continue printing by pressing ONLINE however the printer is due for service
On 2             Blink Blink INK OUT - The printer is out of INK , Note any combination of BK, C, M or Y may blink Replace or check the ink cartridges that have BLINKING lights - BK = Black, C = CYAN, M = Magenta, Y = Yellow
On 3 Blink             On This indicates Carriage Error (Printhead movement) See notes below on Encoder Errors. If that doesn't work, printer requires a service
On 3 Blink           On   Home Position Error (Printhead movement) Requires Service
On 3 Blink           On On Encoder Error (Printhead movement) See notes below on Encoder Errors. If that doesn't work, printer requires a service
On 3 Blink         On     Paper Feed Motor Error Requires Service
On 3 Blink         On   On Auto Sheet Feeder Home Position Error Requires Service
On 3 Blink         On On   Internal Temperature Error Requires Service
On 3 Blink       On       WASTE INK is Full Requires Service
On 3 Blink       On     On This indicates EEPROM Error Requires Service
On 3 Blink   ON           ROM Error Requires Service
On 3 Blink   On     On     RAM Error Requires Service
On 3 Blink       On   On   Gate Array Error Requires Service
On 3 Blink       On   On On Ink Detection See Notes for Recalibration Method
On 3 Blink               PrintHead Error Requires Service, Possibly remove printhead and reinstall may resolve problem. Any combination of BK,C,M,Y may be be blinking

Сброс кода ошибки переполнения отстойника - "памперса"

1: Unplug Power Cord
2: Hold POWER and FF and Print Mode and Envelope buttons
3: Plug in Power Cord
4: Release after the beeps

If you receive an encoder error, try the following,

  • Power off the printer
  • Unplug the printer power cord
  • Hold PRINT MODE and POWER buttons and plug in the printer's cord
  • Release the buttons after the tones (beeps)
  • Wait until the printer finishes, and power off
  • Unplug the printer
  • Plug it back in.

© E.Semenov, 2002-2003