МАНУАЛЫ

CANON BJС-600e

КОДЫ ОШИБОК
Power Beeps Error Online BK C M Y Env Thick Error Condition Solution
On   Off On             Ready  
On 2 On               Paper jam or out of paper Add paper or remove the paper jam and press ONLINE to continue
On 2             Blink Blink WASTE INK warning You can continue printing by pressing ONLINE however the printer is due for service
On 2             Blink Blink INK OUT - The printer is out of INK, Note any combination of BK, C, M or Y may blink Replace or check the ink cartridges that have BLINKING lights - BK = Black, C = CYAN, M = Magenta, Y = Yellow
On 3 Blink             On This indicates Carriage Error (Printhead movement) Requires Service
On 3 Blink           On   Home Position Error (Printhead movement) Requires Service
On 3 Blink           On On Encoder Error
(Printhead movement)
Requires Service,
Though See Notes Below
On 3 Blink         On     Purge Error Requires Service
On 3 Blink         On   On Paper Feed Motor Error Requires Service
On 3 Blink         On On   Auto Sheet Feeder Home Position Error Requires Service
On 3 Blink         On On On Internal Temperature Error Requires Service
On 3 Blink       On       WASTE INK is FULL Requires Service
On 3 Blink       On     On This indicates EEPROM Error Requires Service
On 3 Blink   On           ROM Error Requires Service
On 3 Blink   On     On     RAM Error Requires Service
On 3 Blink       On   On   Gate Array Error Requires Service
On 3 Blink           Blink Blink PrintHead Error Requires Service, Possibly remove printhead and reinstall may resolve problem. Any combination of BK,C,M,Y may be be blinking

Сброс кода ошибки переполнения отстойника - "памперса"

1: Unplug Power Cord
2: Hold POWER and FF and Print Mode buttons
3: Plug in Power Cord
4: Release after the beeps


If you receive an encoder error, try the following,

  • Power off the printer
  • Unplug the printer power cord
  • Hold PRINT MODE and POWER buttons and plug in the printer's cord
  • Release the buttons after the tones (beeps)
  • Wait until the printer finishes, and power off
  • Unplug the printer
  • Plug it back in

© E.Semenov, 2002-2003