| Error |
Cause |
Solution |
| C1 |
Waste Ink Warning |
Press Online to continue printing, Note to
stop this error you are require to take the printer in for
service. |
| C5 |
Low Battery Warning |
Try recharging the battery |
| E1 |
Paper Pickup Error or out of paper |
Add Paper or clear paper jam and press the
ONLINE button. |
| E2 |
Paper Delivery Jam |
Clear paper jam and press the ONLINE button. |
| E3 |
Cannot switch between cut sheets and fanfold
paper. |
|
| E6 |
Not detecting the print head |
Install the print head or replace it |
| F1 |
Carriage motor / home position related errors |
Try unplugging the printer for 60 seconds,
if that fails then the printer Requires a Service |
| F3 |
Encoder related errors |
Try unplugging the printer for 60 seconds,
if that fails then the printer Requires a Service |
| F11 |
Internal thermistor error |
Try unplugging the printer for 60 seconds,
if that fails then the printer Requires a Service |
| F12 |
PrintHead Temperature Error |
Try installing a NEW print head , if the
problem continues the printer requires service |
| F13 |
Print Head Installation Error |
Try installing a NEW print head or reinstalling
the print head, if the problem continues the printer requires
service |
| F14 |
Waste Ink is Full |
Requires Service |
| F15 |
Error detected when capping cartridge |
Try unplugging the printer for 60 seconds,
if that fails then the printer Requires a Service |
| F1a |
Error detected when checking the RAM |
Try unplugging the printer for 60 seconds,
if that fails then the printer Requires a Service |
| F1b |
Error detected when checking the ROM |
Try unplugging the printer for 60 seconds,
if that fails then the printer Requires a Service |
| F1c |
Error detected when checking the EEPROM |
Try unplugging the printer for 60 seconds,
if that fails then the printer Requires a Service |
| F1d |
When the head subheater fuse on printer logic
board has blown, or when electrical conductivity of the subheater
is abnormal |
Requires Service |
| F1f |
The optional interface was selected, but
no board was installed, or an error occurred in communication
with the board |
May Require Service |
| Online blinking |
Check and see if the print head is sitting
in the middle |
Typically means replacement of the print
head, try reseating the print head |
