МАНУАЛЫ

CANON BJС-2000

КОДЫ ОШИБОК

The BJC-2000 does not beep or have any LEDs to indicate errors. All errors are reported via the computer with error messages.

Error Condition Error Indication
on Computer
Error
Code
Possible Solution
Paper Feed The Printer is out of paper   Add Paper
Paper Jam A paper jam has occurred   Remove any paper jammed
Cover is open The printer's front cover is open   Close the front panel
No cartridge BJ Cartridge error occured   Install the BJ cartridge properly and close the printers front cover.
Head Mismatch An incorrect cartridge was installed in the printer.   Insure the scanner IS cartridge is installed when scanning or the BJ Cartridge is installed when printing
EEPROM An error that possibly requires a service call has occurred 6800 Try unplugging the printer for 30 seconds, if not requires a service.
Home Position An error that possibly requires a service call has occurred 5000 Make sure no obstructions are blocking the cartridge movement, if not needs service.
Carriage Error An error that possibly requires a service call has occurred 5100 Try unplugging the printer for 30 seconds, if not requires a service.
Temperature Sensor An error that possibly requires a service call has occurred 5400 Try unplugging the printer for 30 seconds, if not requires a service.
No Cartridge Error An error that possibly requires a service call has occurred 5600 Try reinstalling Cartridge or replacing the cartridge
Waste Full An error that possibly requires a service call has occurred None Needs Service
Cleaning Error An error that possibly requires a service call has occurred 5C00 Make sure no obstructions are blocking the cartridge movement, if not needs service.
Scanner IS-22 An error that possibly requires a service call has occurred 5210  

Сброс кода ошибки переполнения отстойника - "памперса"

1: Remove the Cartridge
2: Unplug the AC Power Cord
3: Close Front access panel
3: Hold down the RESUME/RESET button and plug in the AC power cord
4: Release RESUME/RESET after plugging in the AC Power cord.
5: Press the RESUME/RESET once within 5 seconds and release the RESUME/RESET .
6: Press and HOLD RESUME/RESET for two seconds or more and release it.
7: Press and HOLD RESUME/RESET for two seconds or more and release it.
8: Unplug AC Power Cord to set data.


© E.Semenov, 2002-2003